Dot Hill Systems SANnet II 200 Manual de servicio descargar pdf (Pagina 112)

7-4 SANnet II 200 FC, SATA, and SATA SE Array Installation, Operation, and Service Manual • March 2005

7.1.5 The VERITAS Volume Manager ASL

VERITAS has provided an Array Software Library (ASL) that must be installed on the

same host system as the Volume Manager 3.2 or 3.5 software to enable the software to

recognize a FC or SATA array.

7.2 Battery Operation

The battery LED (on the far right side of the I/O controller module) is amber if the

battery is bad or missing. The LED blinks green if the battery is charging and is solid

green when the battery is fully charged.

7.2.1 Battery Status

Battery status is displayed at the top of the initial firmware screen. BAT: status

displays somewhere in the range from BAD to ----- (charging) to +++++ (fully

charged).

For maximum life, lithium ion batteries are not recharged until the charge level is very

low, indicated by a status of -----. Automatic recharging at this point takes very little

time.

A battery module whose status shows one or more + signs can support cache memory

for 72 hours. As long as one or more + signs are displayed, your battery is performing

correctly.

Table 7-1 Battery Status Indicators

Battery

Display Description

----- Discharged; the battery is automatically recharged when it reaches this

state.

+---- Adequately charged to maintain cache memory for 72 hours or more in

case of power loss. Automatic recharging occurs when the battery

status drops below this level.

++--- 90% charged; adequate to maintain cache memory for 72 hours or

Sin comentarios

Dot Hill Systems SANnet II 200 Manual de servicio Pagina 112